Rice Lake Livestock Solutions - Contrast Control Installation for 920i Weighcenter - Manual (Page 3)

Contrast Control Potentiometer Installation 3
6. Locate J14, J16, J17 on the CPU board and remove the black jumpers.
Figure 7. Locate and Remove Jumpers
7. Install the 8-pin connector as shown in Figure 8 making sure red wire is on Pin 1 of J14.
Figure 8. Eight Pin Connector
8. Using the splice taps, connect the wires from the potentiometer to the wires from the connector, see Figure 9.
• Red to red
• White to white
• Black to black
Figure 9. Connect Wires
Remove Jumpers
Connector - Red
wire on pin1 of J14
Red to red
White to white
Black to black