Rice Lake Mobile Group Animal Scale - MAS-M - Operators Manual - Manual (Page 22)

18 MAS-M Operator’s Manual
3.0 Towing Instructions
Read these instructions before towing.
This unit is not intended for the transportation of livestock or any
other goods. Any addition of weight to the scale in transport
mode may cause premature component failure and voids the
Rice Lake warranty.
The scale must be in “Transport Mode” to be towed. See Section 3.1.2 on page 22 for
converting to transport mode.
The scale is designed to be towed level (frame parallel to the ground) using a 2” ball.
To achieve the level towing condition, the required hitch height of the towing vehicle
must be approximately 16”. If the hitch of the towing vehicle is not in this range, use
an adapter to achieve a height in this range. The hitch weight of the scale is
approximately 500lb. An equalizer hitch may be used for towing if desired (such as
the EAZ-LIFT Adjustable Weight Distributing Hitch #1009).
Safety chains must be connected during towing (see Figure 3-1). Connect the safety
chains. Cross the chains under the hitch for proper protection. Safety chain length is
adjustable by inserting the quick link through any link of the chain.
Figure 3-1. Hitch Connection
The scale must be connected electrically to the tow vehicle. Ensure that the
wiring of the towing vehicle is compatible with the scale wiring before hooking up.
See the label on the hitch for the wiring code (or see Figure 5-9 for wiring diagram).
The scale is supplied with a 7-pin connector. It is crucial the wiring is correct so the
battery (which supplies power to the control box) is charged during transport.
Improper wiring can cause brake failure.
If the scale is to be towed at night or if the lights of the tow vehicle are
obstructed by the scale, add on lights are available. These lights plug into a 6-pin
receptacle located on the rear of the battery box and attach magnetically to the
scale frame.
WARNING
Use Adapter
If Required
Cross Chains
Under Hitch
Adjust Safety Chain
Length Here
Hook Up
Electrical
Cable
Attach Breakaway
Switch Cable
To Truck Frame
WARNING