Rice Lake Loadrunner Dump Truck Systems Kit - Manual (Page 18)

14 LoadRunner™ Series Installation & Service Manual
The following configuration and calibration instructions require symbols to make selections. When selecting a
symbol, press the corresponding key below the symbol. See Figure 4-2.
(OK) Symbols
Keys
Figure 4-2. Symbol Keys
4.2 Initial Setup of the OB-350 Indicator
The system password allows access modification of the options: Configuration, Calibration and System Setup
menus. When in the configuration and setup menus, the function keys will perform the following functions:
M
E
N
U
(OK)
Diagnostics
Alarms
Options
Configuration
Calibration
System
A B C D
E
Figure 4-3. Setup Mode
A Accept or Enter key - enters data
B Down arrow key - scrolls down within the menu selection
C Up arrow key - scrolls up within the menu selection
D
Carriage Return/Circle - Previous screen or back function
When in a menu function (password) and OK is not visible, use this key as the enter and accept.
E Selectable MENU options
Options Modes Select weighing mode to be displayed - Net. Gross or Net & Gross. See Section 4.6.
Load/Chan Load function gives the option to accumulate the amount of load (weight) delivered or
collected from site.
Channel Function - Split screen function is added to the MENU screen.
RS-232 Select or change RS-232 output option.
Count Select count by in kg - 1, 2, 5, 10, 20, 50, 100, 200,
Z/Func Allows operator access to Zero/Tare function on the display.
Inc For use with roll off systems and dump trucks, turn on to calibrate zero degrees of
inclinometer.
Configuration Input 1(F)
Input 2 (R)
Split
CAN Air/Oil pressure transducer or load cell setting on truck type.
Air/Oil pressure transducer or load cell setting on truck type.
Setting varies depending on input 1/input 2 values.
Not Used
Calibration Tare
Zero
Span Entry of empty vehicle weight for gross weight calculation.
No load zero calibration.
Entry of load for span calibration.
System Pin
PUK
Clock Enter a password.
Not Used.
Change system time and date.
User and Setup Menu
Parameter Choices Description
Table 4-1. User and Setup Menu – Electrical Wiring and Data Connections