Rice Lake Loadrunner Dump Truck Systems Kit - Manual (Page 20)

16 LoadRunner™ Series Installation & Service Manual
4.3 Configuration of Count By
The count by value in the division size, in lbs, that the scale will increment by
on the display.
1. Use or to scroll to Option . Press (OK).
2. Use or to scroll to Count . Press (OK).
3. Use or to scroll to the Count By value. Press .

Selectable count by values are 1, 2, 5, 10, 20, 50, 100 and 200 lbs.
Note
Rice Lake Weighing Systems recommends using 20 lb minimum.
Choosing a lower weight value may cause your weight to fluctuate on the display and returning to zero weight
may be more difficult.

Example: If 50lb is selected, the weight values will increase by a factor of 50lbs: 50, 100, 150, etc.
4. Scroll to Z/Func: and press (OK) .
4.4 Configuration of Zero Function
The Zero function setting allows you to turn on and off the zero key when in normal weighing mode.
Selectable zero function settings are:
• Allow Keypad Zero – Activate container tare (Gross Mode) or Zero (Net Mode) button on main menu to
zero load up to 1100 lbs of weight by the operator.
Note When the tare button is pressed in gross mode, the weight will return to the original empty weight tare value.
• Inhibit zero – De-activate operator zero functionality
To set the Zero Function:
1. In MENU , select Options .
2. Press (OK).
3. In OPTIONS menu, select Z/Func .
4. Press (OK).
5. Use or to scroll to desired option.
6. Press to confirm setting.
7. Zero is be added to the MENU screen.
4.5 Configuration of Inclinometer Calibration
On dump truck and roll off applications, the load runner system uses the load
pins and hydraulic pressure transducer to determine a weight value. To achieve
the best accuracy, calibrate the system at the same incline that weight will be
read, with +/- 1-2°.
The Inclinometer setup screen shows both the body angle in a numeric value
and absolute angle (abs 0.0). For this application, use the level indicators,
which light up for every degree the body is raised.
The numeric value will indicate a negative value as the body is raised, which is
normal. The level indicators to the right will light up, 1° per circle.
The inclinometer function allows visual determination of the height of the body
to achieve an accurate weight value consistently.
1. Make sure the truck is on a level surface and the body is in the down
position.
2. Scroll to Option , press (OK).
3. Scroll to Inc , press (OK).
4. Use to scroll to ON.
5. Ensure the body is in the down position and the truck is on a level
surface.
6. Press CAL to zero the inclinometer.