Rice Lake Mechanical Beam Baby Scale RL-MIS-20 (KG Only) - Manual (Page 6)

2 Mechanical Baby Scale Installation and Operation Instructions
2.0 Installation Instructions
You will receive your Rice Lake Mechanical Baby Scale partially assembled. Those items that need additional
assembly are:
• Pillar assembly
• Steelyard rod connection
• Molded plastic weighing tray assembly
Remove all components from the shipping box and lay out in a convenient place.
2.1 Pillar Installation
Prior to assembly, you’ll need the following tools to finish assembling the Rice Lake Mechanical Baby Scale.
• Phillips head screwdriver
• Multi-purpose tool (included)
The pillar comes separate from the scale base and must be attached prior to use. Use the following steps to attach
the pillar to the scale base.
1. Set the scale base on a table or other convenient place with the bottom facing upwards (shown in left side
photo in Figure 2-1).
2. Remove twisty tie off of the scale base as shown on the left hand side of Figure 2-1. Remove the cable tie
that holds the steelyard rod from shifting during transit (shown in right side of Figure 2-1).
Remove cable tie from steelyard rod
Remove twisty ties
from scale parts
Figure 2-1. Remove Cable Ties