Rice Lake Mechanical Beam Baby Scale RL-MIS-20 (KG Only) - Manual (Page 9)

Mechanical Baby Scale Installation and Operation Instructions - Weigh Platter Installation 5
3.0 Weigh Platter Installation
The weighing platter comes separate from the scale base and must be attached for proper operation. To attach the
weigh platter to the scale base, use the following instructions.
1. Position the weigh platter on top of the scale platform with the inch/cm marks located next to the pillar as
shown in Figure 3-2.
2. Line up the screw holes as shown in Figure 3-1.
Figure 3-1. Weigh Platter Screw Hole Location
3. Using a Phillips head screwdriver, tighten up the four screws to secure it to the scale platform.
I n c h / c m m e as u rin g r u l e r
located next to the scale
pillar.
Figure 3-2. Weigh Platter Attached to the Scale Base