Rice Lake Mechanical Chair Scale (RL-MCS) - Manual (Page 8)

4 Mechanical Chair Scale Installation and Operation Instructions
2.3 Installing Transport Handle
Once the pillar and beam are attached to the scale support frame and secured, it’s time to attach the transport
handle to the scale support frame (transport handle is illustrated in Figure 2-6).
1. Remove the four side screws (two on each side as shown in left hand side of Figure 2-6) from the scale
support frame and set aside. The transport handle will attach to the scale support frame using those
screws.
Figure 2-6. Transport Handle Installation
2. Insert the transport handle into the two sides of the scale support frame (shown in right side of
Figure 2-6).
3. Insert and tighten the four screws using a Phillips screwdriver as shown in Figure 2-7.
Figure 2-7. Insert and Tighten Four Screws for Securing the Transport Handle to the Scale Support Frame
The transport handle should fit snuggly against the scale support frame.
Transport handle
Side screws x 4