Rice Lake Prove Statistical Printer - Manual (Page 15)

Appendix 11
5.5 Opening the Paper Reservoir Lid
To open the printer, squeeze and pull the level upward and forward until the lid is
released from its locked position. To avoid damage to the unit, do not use excessive
force.
Figure 5-2. Opening Paper Reservoir
5.6 Replacing Paper Roll
When the paper roll needs replacing, use the following steps.
1. Open the paper reservoir lid and remove the remaining paper.
2. Reel off a few centimeters from a new roll of paper.
3. Hold approximately five centimeters of paper outside the printer as the roll is
placed into the reservoir.
4. Close the lid by applying gentle and equal amounts of pressure on each side
until the lid is in the locked position. Now tear the surplus away.
The thermal side of the paper should be facing forward.
Figure 5-3. Replace Paper Roll
5.7 Disposal
If in use in the EU the printer should be disposed of in accordance with the Waste
Electrical and Electronic Regulations (WEEE Regulations). This also applies with
national requirements in other countries.
The Prove statistical printers contain batteries that should be disposed of by a
qualified hazardous material handler.
Note