Rice Lake RS-130 - Operation Manual - Manual (Page 8)

JP1 Settings
Disable Enable
JP1
4 RS-130 Operation Manual
Figure 2-1. Jumper JP1 Location
Follow the steps below to re-assemble the scale.
1. Place the cover on top of the base, ensure that the sealing pin is aligned with the sealing pin hole in the base.
2. Tighten the four screws into the base of the scale.
3. Replace the lead seal in the center of the base, over the sealing pin.
4. Replace the platter and plastic in-use cover.
Sealing Pin
Figure 2-2. Sealing Pin