Rice Lake Zebra RW 420 Vehicle Cradle - Manual (Page 12)

12
RW 420 Vehicle Cradle Installation Guide
3. Connect red cable power (+) terminal to vehicle power
source.
Secure the Power Cable
Secure the Input Power along its entire length with the supplied
adhesive-backed clamps.
. Make sure that the cable routing does not interfere with other
equipment or vehicle controls. Insure that the cable routing pro-
tects the cable from damage during vehicle use.
Using the Printer in the Vehicle Cradle
Printer Preparation
Prepare the printer for installation into the Vehicle Cradle by do-
ing the following:
It is strongly recommended as a safety precaution that the adjustable
shoulder strap be removed prior to docking the Printer. This precaution will
ensure the strap will not interfere with proper operation of the vehicle.
• Always install the Battery prior to mounting the printer in the
Cradle.
• Remove the Docking Connector Cover from the bottom of
the printer, and retain it for future use. (Refer to Figure 4)
Figure 4: Printer Preparation
Remove and re-
tain the Docking
Connector Cover
and attaching
Hardware