Printer installation – Rice Lake Zebra RW 420 Vehicle Cradle User Manual
Page 13
13
RW 420 Vehicle Cradle Installation Guide
Printer Installation
The RW 420 Printer can now be installed in the Vehicle Cradle:
• Place the bottom of the printer over the two pins in the
Cradle.
• Rotate the Printer into the Cradle and press firmly until it
latches in place.
• Turn the vehicle’s power source for the Cradle on, and veri-
fy that the power indicator light and the charger light on the
Cradle’s front panel are lit.
If the charge indicator does not light up, unlatch the printer from the
Vehicle Cradle, lift it clear from the Cradle and reseat it.
• Turn the printer on and print a configuration label to verify
that the printer is functioning properly. Refer to the RW 420
User’s Guide for instructions on printing a configuration la-
bel.
Figure 5: Installing the Printer In The Vehicle Cradle
Place the Printer
over the retaining
pins in the Cradle.
Rock the Printer into the
Cradle to latch it in position.