Rice Lake Zebra RW 420 Vehicle Cradle - Manual (Page 19)

19
RW 420 Vehicle Cradle Installation Guide
printing media, operate the printer’s controls and perform routine
maintenance such as cleaning the printhead. Follow these steps:
1. Select a location in the vehicle that will avoid personal con-
tact in case of an accident.
2. Turn the Cradle upside down, and plug the input power cable
into the bottom of the Cradle.
• Route the input power cable out of the Cradle. Note that it
can be routed out either side of the Cradle and that there are
retaining features in the Cradle to keep the cable in place.
Refer to Figure 3.
• Be sure to leave enough slack in the power cable to allow
the Mounting Arm to pivot freely without putting strain on
the power connections.
• Make sure that the input power cable routing does not in-
vite damage to the cable when the Vehicle Cradle is pivoted.
3. Once the cable routing has been determined, secure it to the
Vehicle Cradle with the cable clamp(s) supplied with the in-
stallation kit. Use the self-tapping screws and flat washers
supplied in the kit to attach the clamp to the Cradle.
4. Secure one of the mounting flanges from the movable Arm
to the bottom of the Vehicle Cradle with the (4) #8-32 x 1/2”
Screws supplied with the Mounting Arm.
5. Secure the other mounting flange on the Movable Arm to
the desired mounting surface. You can use the #10-24 x 3/4”
Screws and associated hardware supplied in the Mounting
Arm Kit or use other hardware as the mounting conditions
dictate.
Input Power Completion
Route the input power cable per the earlier section in this Guide:
“Input Power Cable Completion.”