Rice Lake Allen-Bradley Remote I/O User Manual
Remote i/o, Installation and programming manual
Advertising
This manual is related to the following products:
920i Programmable HMI Indicator/Controller - Remote I/O Indicator Interface, 820i Programmable Indicator/Controller - Remote I/O Indicator Interface Installation and Programming Manual, 720i Programmable Indicator/Controller - Remote I/O Indicator Interface Installation and Programming Manual, 520 Configurable Weight Indicator - Remote I/O Indicator Interface Installation and Programming Manual
Table of contents
Document Outline
- About This Manual
- 1.0 Introduction
- 2.0 Installation
- 3.0 Discrete Transfer Commands
- 3.1 Output Image Table Format
- 3.2 Input Image Table Format
- 3.3 Discrete Command Descriptions
- Return Status and Current Weight
- Display Channel
- Display Gross Weight
- Display Net Weight
- Display Piece Count
- Gross/Net Key Press (toggle mode)
- Zero
- Display Tare
- Enter Tare (integer)
- Acquire Tare (simulate tare key press)
- Clear Tare
- Primary Units
- Secondary Units
- Tertiary Units
- Units Key Press (toggle units)
- Print Request
- Display Accumulator
- Clear Accumulator
- Push Weight to Accumulator
- Return Gross as Integer
- Return Net as Integer
- Return Tare as Integer
- Return Piece Count
- Return Current Display as Integer
- Return Accumulator as Integer
- Return Rate of Change as Integer
- Return Peak as Integer
- Set Batching State
- Batch Start
- Batch Pause
- Batch Reset
- Batch Status
- Lock Front Panel of Indicator
- Unlock Front Panel of Indicator
- Set Digital Output ON
- Set Digital Output OFF
- Read Digital I/O
- No Operation
- Reset Indicator
- Set Register
- Get Register
- 4.0 Block Transfer Commands
- 4.1 Block Write Command Format
- 4.2 Block Read Command Format
- 4.3 Block Transfer Command Descriptions
- Set Tare Value
- Read Gross Weight
- Read Net Weight
- Read Tare Weight
- Read Piece Count
- Read Current Display
- Read Accumulator
- Read Rate of Change
- Read Peak Value
- Read Gross, Tare, Net
- Read Multiple Weights
- Set Setpoint Value
- Set Setpoint Hysteresis
- Set Setpoint Bandwidth
- Set Setpoint Preact
- Set Single Setpoint, All Values
- Read Setpoint Value
- Read Setpoint Hysteresis
- Read Setpoint Bandwidth
- Read Setpoint Preact
- Read Single Setpoint, All Values
- Set Multiple Setpoint Values
- Read Multiple Setpoint Values
- 5.0 Operation
- 6.0 Remote I/O Interface Card Specifications
- Remote I/O Interface Limited Warranty