Rice Lake Allen-Bradley Remote I/O - Manual (Page 18)

14 Remote I/O Installation and Programming Manual
Status Data
Block command status bit definitions are shown in
Table 4-4. Setpoint commands return the setpoint
number in the low byte, batch status in the high byte
of the status word (see Table 4-5).
Table 4-4. Block Command Status Data Format
Word 1
Bit
Status
Bit
Indicator Status Data
Value=0 Value=1
00 s00 Positive weight Negative weight
01 s01 Reserved
02 s02
03 s03 Scale number
(NOTE: Value 0 represents scale #32)
04 s04
05 s05
06 s06
07 s07
08 s08 Gross Net
09 s09 No tare Tare acquired
10 s10 Primary units Secondary/ other
units
11 s11 Standstill In motion
12 s12 Weight invalid /
Over-range
Weight OK
13 s13 Not zero Center of zero
14 s14 Tare not entered Tare entered
15 s15 Error No error
Table 4-5. Batch Function Status Data Format
Word 1
Bit
Status
Bit
Batch Function Status Data
Value=0 Value=1
00 s00 Setpoint number
01 s01
02 s02
03 s03
04 s04
05 s05
06 s06
07 s07
08 s08 Alarm OFF Alarm ON
09 s09 Batch not stopped Batch stopped
10 s10 Batch not running Batch running
11 s11 Batch not paused Batch paused
12 s12 Digital input 1 OFF Digital input 1 ON
13 s13 Digital input 2 OFF Digital input 2 ON
14 s14 Digital input 3 OFF Digital input 3 ON
15 s15 Digital input 4 OFF
( 520 ) Error
Digital input 4 ON
( 520 ) No error