Rice Lake TC Series, Rice Lake Weighing Systems - RS-232 Option Card Installation Manual - Manual (Page 12)

Response Output 8
• Setup of output control
The output controls executed with commands [O0] - [O7] work the same as the output controls executed
through function setup on the main unit of the balance.
The commands [O8] and [O9] are data request commands issued to the balance.
Once any command from [O0] to [O9] is executed, the balance runs that function until another command is
entered. However, if the balance is switched off and on again, the output control is reset to the initial
function (function set value).
1.16 Response Output
• Response output format
Composed of five characters, including the terminators (CR = 0DH; LF = 0AH)
• Types of response outputs