Rice Lake TC Series, Rice Lake Weighing Systems - RS-232 Option Card Installation Manual - Manual (Page 5)

1 RS-232 Option Card
1.0 Installation
Use the following procedure to install the RS-232 option in the TC Series Balance.
1.1 Remove the Case
1. Pull out the AC adaptor from the scale
2. Remove the pan and pan base.
3. Remove the case-fixing screw.
4. Unfasten the hooks on the bottom front while pulling up the case.
Figure 1-1. Location of Parts
5. Unfasten the hooks on the back and remove the case.
Figure 1-2. Back Hooks Location
Hooks
Pan
Pan Base
C a s e
F i x i n g
Screw
Case
Chassis