Seca 763 printer-module - Manual (Page 11)

11
Weighing with printout
– Switch the scale on if necessary.
– Switch on the printer at the on/off
switch.
– Get the patient to stand on the scale.
The patient should then stand still. The
measured weight is printed out.
– If you also want to measure height
(models 763/764 only), perform a
measurement (see "Measuring height”
in the operating instructions for the
scale).
Then press the
Data Valid key. The
height and calculated BMI value are
then printed out.
– When the load is removed from the
scale, date and time are also printed.
Then tear off the printout towards the
tearing edge.
Note:
If the printout is in 12-hour format,
morning times are marked
AM and af-
ternoon times PM.
– If you do not require any further print-
out, switch the printer off again at the
on/off switch.
What do I do if ...
… the scale switches off when attempting to print?
– Too weak a mains power unit is connected. Connect seca mains power unit
68-32-10-263 supplied (see “Connecting the scale” on page 8).
… the printer does not print during weighing?
– Is the printer switched on?
– Is the flap of the paper dispenser completely closed?
… PAPEr appears in the display?
– The paper is finished. Insert a new roll.
– Is the flap of the paper dispenser closed?
… the printer prints during weighing, but there is nothing to be seen on the paper?
– The paper has been put in the wrong way round. Insert the roll the right way round.
on/off switch
on/off switch