Casio ClassPad 300 PLUS User Manual
Page 239
20050501
u Specifying all
x
-values
This method generates a reference table by looking up data stored in a list. A LIST variable is
used to specify the
x
-values. When using this method, it is up to you specify all of the correct
x
-values required to generate the summary table. The summary table will not be generated
correctly if you provide incorrect
x
-values.
The following shows examples of each of the three available summary table generation
methods by generating a table for the function
y
=
x
3
– 3
x
.
3-4-10
Using Table & Graph
x
–1
0
1
f
Ј(
x
)
+
0
–
–3
–
0
+
f
Љ(
x
)
–
–6
–
0
+
6
+
f
(
x
)
2
0
–2
Tip
• You can control whether or not the summary table should include an
f
Љ(
x
) line (quadratic
differential component) using the [Summary Table
f
Љ(
x
)] setting on the [Cell] tab of the Basic
Format dialog box (page 14-3-3). Turning on the [Summary Table
f
Љ(
x
)] option causes both linear
differential components and quadratic differential components to be displayed in the summary
table. Turning it off shows linear differential components only.
k Generating a Summary Table Using Automatically Set
x
-Values
With this method, the summary table is generated using a range of values from –
∞
to
∞
.
u ClassPad Operation
(1) On the Basic Format dialog box, select “View Window” for the [Summary Table] setting,
and specify the value you want for [Cell Width Pattern]. This example uses a [Cell
Width Pattern] setting of “4 Cells”.
• To open the Basic Format dialog box, tap
O, [Settings], [Setup], and then [Basic
Format].
• For additional details about Basic Format settings, see “14-3 Setup Menu Settings”.
(2) Input the function
y
=
x
3
– 3
x
on the Graph Editor window.
• Generation of summary tables is supported for “
y
=” type functions only.
• Clear the check boxes of all other functions on the Graph Editor window, if necessary.
Select the check box next to
y
=
x
3
– 3
x
and press
E.
• If the check boxes of more than one “
y
=” type functions are selected, the one with the
lowest line number (
y
1,
y
2,
y
3, etc.) is used for number table generation.
(3) Tap 6 to display the View Window dialog box.
Summary Table and Graph of y = x
3
– 3x
(The graph to the right is for reference only.)
2
1
–2
–1
–2
–1
1
2