Casio ClassPad 300 PLUS - Manual (Page 299)

20050501
5-3-1
Drawing a 3D Graph
5-3 Drawing a 3D Graph
This section explains how to draw a 3D graph, as well as how to change the angle of a graph
and how to rotate a graph.
Configuring 3D Graph View Window Parameters
3D Graph View Window parameters let you specify the maximum and minimum values for
the
x -, y - and z -axis. You can also specify the number of lines you would like for drawing the
grid.
• For the xgrid enter the number of lines you would like drawn within the interval from xmin to
xmax. For example, if xmin =
−3, xmax = 3 and xgrid= 15, 15 almost vertical lines will be
used to display your graph. The ygrid lines will be almost horizontal.
• After drawing a 3D graph, pressing the = key cycles the 3D Graph [Axes] setting (page
14-3-6) in the following sequence: “Off”
→ “On” → “Box” → “Off”, and so on.
Before drawing a graph, be sure to first configure View Window parameters as required to
ensure proper display of the graph.
u ClassPad Operation
(1) On the application menu, tap D.
• This starts up the 3D Graph application and displays the initial screen of the active 3D
Graph Editor window.
(2) Tap 7 to display the View Window dialog box.
(3) Configure the View Window parameters as described below.
• Press c to move the cursor and input an appropriate value for each parameter.
Use this
item: Initial
default
To configure this View Window parameter:
xmin
xmax
xgrid
ymin
ymax
ygrid
zmin
Minimum x -axis value
Maximum x -axis value
Number of grid lines used for x -axis direction
Minimum y -axis value
Maximum y -axis value
Number of grid lines used for y -axis direction
Minimum z -axis value
zmax Maximum z -axis value
angle Clockwise angle of x -axis
angle
Eye position relative to the plane created by
the
x -axis and y -axis, and the angle of the z -axis
φ
θ
–3
3
25
–3
3
25
–3
3
20
70