Casio ClassPad 300 PLUS - Manual (Page 428)

20050501
(5) After clearing the Main application work area, try repeating steps (3) and (4) for points
A’ and A’’.
• This displays the expression that transformed the coordinates of point A’ to the
coordinates of point A’’.
Important!
• This operation is valid only when a point in the original figure and the corresponding point in
the transformed figure are selected in the Geometry application. Nothing is displayed when
you select points A and A’’ in the above procedure and drag them to the Main application
work area.
Observe this area of the
expression. This corresponds to
the vector values you input when
executing General Transform.
k (b) Operation Example
u ClassPad Operation
(1) On the application menu, tap J to start up the Main application.
(2) Tap the down arrow button on the Main application toolbar. On the button list that
appears, tap 3.
• This opens the Geometry application.
(3) On the Geometry window, tap [Edit] and then [Clear All].
• This clears the Geometry window.
8-2-24
Drawing Figures