Thetford 902 Topline - Manual (Page 9)

9
Electrical Connection
Models fitted with power cord only
This appliance is supplied with a double insulated cord, type 227 IEC 53, HO5V V-F, which is
suitable for use up to 4 amps. This should be connected to a double pole switched mains
supply, with 3mm minimum contact separation at all poles. Ensure that all electrical cables and
wires are routed well clear of any heat source, including this appliance. Do not allow the cord to
hang loose into the lower compartment. The switch must be accessible after installation.
Models fitted with Euro plug and power cord
This appliance is supplied with a Euro plug attached to the end of the power cord, for
connection to a switched wall mounted socket. After connection ensure the power cord and any
other electrical wires are routed well clear of any heat source, including this appliance. Do not
allow the cord to hang loose into the lower compartment. The switched socket must be
accessible after installation.
All servicing must be carried out by an approved competent person. After service the appliance
must be checked for electrical safety.
If servicing requires removal of the appliance:-
(1) Switch off power supply and disconnect appliance from 240V supply.
(2) Release and remove the appliance clamping screws.
(3) Carefully lift out the appliance from the worktop and place on a suitable surface.
If the power cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
SERVICING
•
This appliance is not intended to be operated by means of an
external timer or separate remote control system.
•
The appliance must not be modified or adjusted unless carried out
by the manufacturer or his representative. No parts other than those
supplied by the manufacturer should be used on this appliance.
INSTALLATION