ThingMagic Astra-EX - Manual (Page 8)

Introduction
M6 and Astra-EX User Guide 8

Programming Interfaces - Describes the programming interfaces, including on-reader
applications, where to find code samples, and the LLRP interface.
 Connecting to the M6 and Astra-EX - Describes the methods available for connecting
to the M6 and Astra-EX over the ethernet, WiFi and USB Console interfaces.
– Setting Up the Reader - Connect using a direct ethernet connection from a
Host PC to the M6 and Astra-EX.
– Networking the Reader - Connect over ethernet LAN or WiFi using DHCP or
static IP settings.
– Connecting to the USB Console Port - Connect to the M6 and Astra-EX
console for command-line interface access and troubleshooting.

Using GPIO - Details the GPIO physical interface specs and how to control it via the
MercuryAPI.

Controlling the Reader - Describes the browser-based interface and the configuration
and testing options available through it.
 Advanced Reader Functionality - Provides descriptions of the M6 and Astra-EX
advanced protocol specific configuration options that ares supported through the use
of the MercuryAPI

Reader RF Power - Provideds guidelines and limitations for setting the RF Power of
the M6 and Astra-EX.

Mounting the Reader and Appendix B: M6 and Astra-EX Dimensions - Provides
details of the physical dimensions of the M6 and Astra-EX.
 M6 Specifications
 Compliance and IP Notices
 Appendix A: M6 and Astra-EX Antenna and Cable Information - Lists the authorized
Antennas and cables which can be used with the M6 and Astra-EX-NA in FCC
regions.

Appendix C: Advanced Administration - Provides the steps for some advanced
administration settings, such as changing reader passwords.

Appendix D: Troubleshooting - Provides recommended debugging steps for common
problems along with data to gather when submitting a problem case to ThingMagic
support.