ThingMagic Nomad RFID Setup Guide User Manual
Page 12
12
Nomad RFID Reader Setup Guide
3.
Remove screws from WWAN cellular antenna, if present.
WARNING
: DO NOT remove
the cellular antenna, it will damage the antenna.
4.
Attach Nomad RFID reader to battery door. Insert the Spacer first, if non-cellular device.
5.
Ensure the reader cable is secured under the wire guide and allows the battery door to
seat properly.
6.
Screw six screws to secure unit: 4x battery door, 2x for WWAN antenna connection.
7.
Install the USB protective bumper as shown below. Paste the supplied adhesive strip on
the back of the USB bumper and firmly press the bumper onto the Nomad USB boot. The
final assembly is also shown below.
8. Attach the USB cable to the Nomad USB boot. The final assembly is shown below.
WARNING:
Do not connect the RFID Reader’s USB cable until after the software
installation is completed.
Paste the supplied adhesive strip onto the back of the USB bumper.
Final assembly of the USB bumper before USB cable installation