Torbal AGC Series Quick Reference Guides - Manual (Page 3)

AGC Series: Quick Reference Guide
Check Weighing
Before using this reference guide, enable and configure Check Weighing by following the steps listed in Chapter 7.1.3
of the Instruction Manual. To enter the Check Weighing mode press the “Function” key, and select the function by
pressing the “T” key while “Check” is displayed.
1. Upon entering the check weighing function, the UNDER limit is displayed. If an under limit has already been set
and no change is necessary, press “T” (YES) to accept and continue. If you wish to change the setting, press the
“0 (NO)” key. To set a new weight limit use the table below.
1