Torbal AGC Series Quick Reference Guides - Manual (Page 7)

AGC Series: Quick Reference Guide
Parts Counting
Before using this reference guide, enable and configure Parts Counting by following the steps listed in Chapter 7.1.3 of
the Instruction Manual. To enter the Parts Counting mode press the “Function” key, and select the function by pressing
the “T” key while “Parts” is displayed.
1. Place a container on the pan and tare it by pressing the “T’ key.
2. Confirm the sample size by pressing the “T (Yes)” key.
3. Manually count out the sample and place it in the container located on the pan.
1