Tycon Power TPW-400DT 12/24V 400W Turbine - Manual

Page 1
A. NOTICE
1. This information is believed to be reliable; however, we assume no
responsibility for inaccuracies or omissions. The user of this
information and product assumes full responsibility and risk.
2. All specifications are subject to change without notice.
3. Wind turbines must be installed following the guidelines
established by local regulations.
B. SAFETY PRECAUTIONS (Important)
1. Safety must be the primary concern as you plan the location,
installation and operation. Please be aware of electrical,
mechanical and blade hazards.
2. DO NOT install the turbine where anyone could approach the
blades.
3. Use common sense and be careful.
4. Select the correct wire size, and the correct fuse size.
5. When installing, please make sure that the turbine is disconnected
from the batteries.
6. Do not let the blades spin freely until the turbine is mounted on the
pole.
7. Never approach the turbine during operation.
C. About this wind turbine
1. The wind turbine has an embedded charge controller with dump
load. It controls battery charging and protects the wind turbine in
high winds.
2. The wind turbine is designed to charge Lead-Acid batteries. It is
12V/24V auto select. It can only work with a 12V or 24V battery
voltage. Please Do Not connect it to other battery voltages.
3. When connecting to the battery, please make sure that the RED
wire (+) of the wind turbine connects to battery V+ (positive) and
the BLUE wire (-) of the wind turbine connects to battery V-
(negative).
TPW-400DT 12/24V 400W Turbine
User Guide