Tycon Power TPW-400DT 12/24V 400W Turbine - Manual (Page 2)

Page 2
4. Incorrect battery voltage or incorrect wire connection may
damage the wind turbine, and these are not covered by the
warranty.
D. Package Contents
Figure 1: Package list
The wind turbine is shipped partially disassembled. Please compare the
parts shown above to ensure that all necessary parts are included.
1 Mainbody 1 pcs
2 Hub 1 pcs
3 Nose Cone 1 pcs
4 Blade 6 pcs
5 Tail Vane 1 pcs
6 Manual 1 pcs
7 Fastener & Tools →
E．Preparing for installation
E.1 The following general tools may be required for installation .
Multi-meter Wrench or spanner Soldering iron
Screw driver Heat shrink or electrical tap
E.2 Pole or Mast
1. This wind turbine is designed to fit an aluminum or steel tube with
an inside diameter of 41mm. An inside diameter 41mm (1.6” or 1
5/8”) steel pole is readily available（water pipe or scaffold tube).
Usually it has an internal weld seam. The wind turbine mount has a
flat on one side to clear the seam. Please do not use plastic pipe.
2. A suitable mounting pole can be erected using a 6 meter
galvanized pipe supported by 3 or 4 guy wires. Figure 4
Fastener Pcs
M16 Nut 1 For Hub
Φ6*30 Screw 15 + 1(spare) For blades & tail
M6 Nut (Nyloc) 15 + 2(spare) For blades & tail
5mm Hex Key 1