Cambridge SoundWorks FPS2000 - Manual (Page 10)

REAR
RIGHT
6
F
Attaching The Floor Stands
by feeding it down the length
of the full length slot. At each
end, feed the cable through the
short notches (see diagram G).
2. Insert the satellite end of the
leg/cable assembly into the
middle socket of the apex joint.
Make sure the satellite cable
exits through the short notch
and not the full length slot
(see diagram F).
The rear satellites (with their
desktop stands attached) may be
installed in their floor stands.
1. One leg of each floor stand has
a full length slot, with short
notches opposite the slot at
each end. Insert a satellite
cable inside one of these legs
3. Insert the two solid legs into
the outside sockets in the
apex joint.
4. Position the two “cut-away”
sections of the desktop stand
over the opening in the top of
the apex joint, as shown in
diagram F. Be sure to align the
face of the stand with the face
of the apex joint. Lower the
stand straight down into the
apex joint.
5. Holding the ends of the apex
joint, push on the front of the
desktop stand until it slips back
into the slot in the apex joint.
Confirm a secure fit.
6. At the base of the rear leg,
gently pull on the satellite
cable to remove any
unnecessary slack in the cable.
7. Insert a rubber plug into the
base of each leg, taking care to
feed the cable out the short
notch in the rear leg (see
diagram H).
G
H
FPS2000 Rev.C 4/17/00, 4:09 PM 10