Cambridge SoundWorks FPS2000 - Manual (Page 12)

FRONT
REAR
FPS2000 Digital Subwoofer
FRONT
REAR
DIGITAL
DIN
DIGITAL I/O CARD
SPDIF CABLE
Digital DIN Connector
8
If your Sound Blaster Live! sound
card includes a Digital I/O card,
you can take advantage of the
clear, distortion-free audio
available from its Digital DIN
output.
1. Insert one end of the SPDIF cable
into the DIGITAL DIN output jack
on the
Sound Blaster Live!
Digital I/O card. The position of
the Digital DIN connector on the
Digital I/O card may be different
from this diagram. The Digital
DIN connector is
the only connector with
a 9-pin configuration.
2. Insert the other end of the SPDIF
cable into the DIGITAL DIN input
on the subwoofer (see diagram K).
3. Use the following procedure to
configure the Sound Blaster Live!
sound card for four speakers:
• Bring your mouse pointer to the
top of the monitor screen to
display the Creative Launcher.
• Click on AudioHQ.
• Click on the Speaker tab. The
speaker dialog box will appear.
Volume Control
The FPS2000 Digital system
comes with a separate wired
Volume Control, designed to be
positioned close at hand and
affixed with the semipermanent
mounting strip.
Connect the circular plug at the
end of the Volume Control into the
circular Volume Control jack on
the back of the subwoofer (see
diagram L).
• On the Configuration tabbed
page, select the “4 Speakers”
option.
• A sofa icon (representing you)
appears in the center of the
Preview box, with four speakers
at the corners of the box.
Note: The FPS2000 Digital will
detect the presence of a plug
connected to the DIGITAL DIN
input and give the DIGITAL DIN
input priority. Any signal present
at the AUDIO input will be
ignored. Be sure to remove the
plug from the DIGITAL DIN input
if you wish to listen to a sound
source through the analog AUDIO
INPUT.
Connection To Sound Blaster Live! Via DIGITAL DIN
K L
FPS2000 Rev.C 4/17/00, 4:10 PM 12