Cambridge SoundWorks FPS2000 - Manual (Page 15)

11
most bass output results from the
subwoofer being placed on the floor
in a corner. The least bass output
results with the unit positioned away
from any corners or walls.
Once you have adjusted the Bass
Level Control, leave it in that
position. It should not be used to
compensate for differences in
recordings or games.
The plastic anchors supplied
will be needed to secure the
screws in most wall surfaces.
If so, drill
1 / 4 inch holes in the
wall, then tap the anchors into
the holes until they are flush
with the wall. Then screw the
screws into the anchors until
they protrude about
1 /
4
inch.
Be sure to apply the stick-on
rubber feet to the back of the
satellite cubes. This assures an
acoustically secure installation.
Keyhole slot mounting
Have a clear line of sight from your
listening position to the satellites.
This prevents their higher
frequencies from being blocked. It is
not necessary for each satellite to be
aimed directly at the listener.
The relative strength of low-bass
depends on how close the subwoofer
is to intersecting room surfaces. The
Optimizing The Sound
Of Your System
Mounting The Satellites
To the wall:
To wall-mount the cubes on
structurally strong surfaces (a wall
stud or wood panelling), screw a
M5 x 25mm screw into the
material. Allow their heads to
protrude about
1 /
4
inch to fit into
the keyhole slots on the back of
each cube (see diagram O).
O
FPS2000 Rev.C 4/17/00, 4:10 PM 15