Welch Allyn MicroTymp 3 portable tympanometric instrument - User Manual - Manual (Page 45)

Directions for use Printing 226-Hz results 45
Change from manual to automatic printout
Automatic vs. Manual Printout (Switch #1)
Change printout format
Use Switches #2 and #3, located on the bottom of the Printer/Charger, to change printout
format. Printout options are shown below.
Auto Print Depress the ON portion of the switch to select this option.
This causes the printout to begin automatically once the
Handle is placed in the well, and data transfer is complete.
Manual Print Depress the OFF portion of the switch to select this option.
This causes the printout to begin only when the PRINT button
is depressed.
1 2 3 4
OFF
1 2 3 4
OFF
Note In the manual mode, a beep will occur as a reminder that data has been
transmitted; however, it is not necessary to wait for the beep before pressing
the PRINT button.
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF OFF
1 2 3 4
Tympanogram Only
(Switch 3)
Tympanogram and
Data (Switch 3)
Messages
(Switch 2)
No messages
(Switch 2)