Welch Allyn EarlySense System 1.0 - Equivalent to model EverOn 1.0 - User Manual - Manual (Page 51)

45
The active mode of the Bed Exit alert is indicated by the bell icon at the Bed Exit section
of the Home screen (Figure 27).
Figure 27: Bed Exit Box
Patient Turn
Patient Turn is used to document change of the patient’s positioning in bed and to
produce an alert if the interval set for changing the position has been exceeded (timer
expired). The Patient Turn alert is also disabled by default.
Setting the Patient Turn Interval
The turn interval is referred to as "q". For instance if you would like the system to
generate an alert as a reminder to turn the patient every 2 hours, set q to q2.
To change the time interval between the turn reminders touch the q button in the Patient
Turn box (Figure 28) in the Home screen (Figure 8). Using the arrows, choose the
relevant q number (number of hours). After 3 sec the arrows will disappear and the
change will be applied.
Figure 28: Setting Patient Turn Interval
Starting the Patient Turn Counter
To enable and disable Patient Turn counter touch the Bell Icon in the Patient Turn
section that is in the Home screen. The counter will become enabled (Figure 30). To
disable the counter press the Bell icon again (Figure 29).