Welch Allyn Connex ProBP 3400 digital blood pressure device - User Manual - Manual (Page 16)

WARNING Welch Allyn is not responsible for the integrity of any mounting
installation. Welch Allyn recommends that customers contact their Biomedical
Engineering Department or maintenance service to ensure professional installation
for safety and reliability of any mounting accessory.
WARNING The device is not defibrillator proof.
WARNING The device may not function properly if dropped or damaged. Do not
use the device if you notice any signs of damage. Qualified service personnel must
check any device that is dropped or damaged for proper operation before putting
the device back into use.
WARNING Defective batteries can damage the device. If the battery shows any
signs of damage, leakage, or cracking, it must be replaced immediately, and only
with a battery recommended for or supplied with the device.
WARNING Improper disposal of batteries may create an explosion or
contamination hazard. Never dispose of batteries in refuse containers. Do not
dispose of the battery in fire. Always recycle batteries according to local
regulations.
WARNING Improper handling of the battery can lead to heat generation, smoke,
bursting, or fire.
WARNING Do not remove the label from the battery.
WARNING Do not disassemble, modify, or solder the battery.
WARNING Do not directly connect or short circuit the positive (+) and negative (-)
battery terminals.
WARNING To avoid short circuits, keep battery terminals away from metal
objects.
WARNING Do not expose the battery to temperatures higher than 80 °C/176 °F.
WARNING If the accuracy of any measurement is in question, check the patient's
vital sign(s) with an alternate method and then check to verify the device is
functioning properly.
WARNING For proper patient electrical isolation and battery charging, use only
the provided external power supply to charge the device.
WARNING Electric shock hazard. Use the USB connector only to connect to
devices complying with IEC 60601-1 or other IEC standards as appropriate to the
device. The user is responsible for verifying that the system complies with the
requirements of the system standard IEC 60601-1-1 if additional devices are
connected to the ProBP 3400.
WARNING Electric shock hazard. Before cleaning the device, disconnect the
power cord from the power source and the device.
Caution Take care to prevent water or other fluid from entering any connectors
on the device. Should this occur, dry the connectors with warm air. Check the
accuracy of all operating functions.
10 General warnings and cautions Welch Allyn Connex® ProBP™ 3400 digital blood pressure device