Leg tables only, Bc d top view when legs are right side up – Workrite Series VALUE Assembly Instructions for Tables with Right Front Crank User Manual
Page 4
4
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Sonoma Series™ VALUE Workcenters - Assembly Instructions for Tables with Right Front Crank
1
Identify the legs and their orientation
Verify that you have all hardware and tools needed for table assembly
Check your cartons against the list on page 2 or 3 to verify that you have all the parts needed.
You will also need the following tools:
#2 tip Phillips screwdriver
and
7
/
16
" combination wrench
2
or
To identify the leg number, look inside the top of the legs and
you will see a number marking (1, 2 or 3) on the bracket.
Legs can also be determined by their gear mechanisms as follows:
Leg 1:
Top and
side drive
Leg 2:
Two side
drives at
90˚
Leg 3:
Straight
through
side drive
Leg 1:
Top and
side drive
Leg 2:
Two side
drives at
90˚
Leg 3:
Straight
through
side drive
Front
Front
Side of leg with pre-installed
nut and lock washer
1
2
3
3-Leg tables only
Examine top of each leg to determine leg
number.
Arrange legs as shown in diagram.
Legs must be positioned in correct
orientation for table to function.
Note that when you are assem-
bling the table upside down, the
orientation will be reversed.
B
C
D
Top view when legs are right side up