Configuring for tcp/ip – Motorola CG4500 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
B A S I C C O N F I G U R A T I O N
The CG4500 contains all necessary software. You don’t need to configure the
CG4500, but you must configure your computer for TGP/IP and check for an IP
address. Your service provider may provide additional instructions for setting up
your computer. The following basic instructions are for Windows 95 or
Windows 98. Use Microsoft online help to install and configure hardware for
Windows 2000 and Windows Me. If you are using a different operating system, refer
to that user guide.
Configuring for TCP/IP
N
On the Windows Desktop, click Start.
2
Select Settings and then Control Panel from the pop-up menus.
3
Double-click the Network icon on the Control Panel window.
4
Select the Configuration tab on the Network window.
R
Check to see if TCP/IP has been installed for the Ethernet or USB
card. If TCP/IP appears in the list of network components, it is
installed and you can proceed to step 10. If it doesn’t appear on the
list, continue with step 6.
2 0