Code Alarm CA-630 - Manual (Page 4)

4
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press* the
LOCK button. The horn will “chirp” twice
† and the parking lights will
flash twice, indicating the system is armed. The doors will also lock at
this time (if equipped and connected). The status indicator (blue
warning light on the dash) will blink steadily, once per second.
Pre-arm Mode
If the horn chirps and the parking lights flash only once, this indicates
that the vehicle courtesy light is on, or that an entrance is not closed
securely. Check to see that doors, hood, and trunk are properly
closed. Once all entrances are secured (and the courtesy light is off),
the system will chirp / flash again. The system is now fully armed.
(If the entrance is not secured within 4 minutes, the system will arm
and ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system, press the UNLOCK button. The horn will chirp
and the parking lights will flash once, and the doors will unlock (if
equipped and connected). The courtesy light will turn on for 1 minute,
or until the vehicle is started.
Two-Stage Door Unlock (optional)
If this feature is enabled on your system, pressing UNLOCK one time
will unlock only the driver’s door. Press UNLOCK again within 1
minute to unlock all doors.
Using the Security and Keyless Entry features
* Throughout this manual, ‘press’ refers to pressing or less than 1 second; ‘press and hold’ refers to
pressing for more than 1 second.
† If you have chosen the Silent Arming Option, the horn will not sound when arming or disarming until the
appropriate button is pressed a second time.
LOCK Button
Press to Arm Security
System and Lock
Doors
FIND/PANIC Button
Press for Car Finder
Press and Hold for
Panic Alarm
UNLOCK Button
Press to Disarm Security
System and Unlock
Doors
Press Twice for Two-
Stage Door Unlock*
Press and Hold to Open
Trunk
START Button
Press and Hold for
Remote Start / Stop
Press to Activate
Rear Defroster