Code Alarm CA-630 - Manual (Page 6)

6
You can turn off all remote start and Security functions by engaging
the Valet/Service Mode:
• To engage Valet/Service mode, turn the ignition key to the ON
position (last position before start) and press the LOCK and
UNLOCK buttons on the remote control simultaneouly. If
installed, the blue status light will blink to indicate Valet mode
• To disengage Valet/Service mode, turn the ignition key to the
ON position (last position before start) and press the LOCK
and UNLOCK buttons on the remote control simultaneouly. If
installed, the blue status light will stop blinking to indicate
Valet/Service mode has been terminated.
Hint: To prevent your security system from automatically arming while
unloading or refueling your vehicle, without placing the system in
Valet mode, simply press the disarm button on your remote control
transmitter after turning the ignition key off. Doing so places your
system into a temporary or one time Valet mode. Next time you exit
your vehicle the system will arm in the normal manner.
Using Your Remote Starter
Starting Your Vehicle
The remote start function is activated by pressing and holding the
START button for 2 seconds on the remote control. The system will
check the vehicle to ensure that it is safe to start, and if all safety
parameters are correct, the engine will start within 5 seconds (diesel
engines will take longer.) Press and hold START again to turn off the
vehicle.
If your vehicle stalls or does not start...
If the vehicle stalls or does not start, the CA-630 will pause 5 seconds,
then try 3 more times to start the vehicle (a total of four attempts). The
system pauses 5 seconds between each start attempt. If the vehicle
does not start after the fourth attempt, the CA-630 will abort the start
process.
Your vehicle can be started by remote control whether the alarm is
armed or disarmed. When the alarm is armed, the impact sensor turns
off when the vehicle is started to prevent the engine vibration from
Remote Start / Stop Feature
Press and hold the START button on the remote control. If all safety
parameters are correct, the engine will start within 5 seconds (diesel
engines will take longer.) Press and hold START again to turn off the
vehicle. (Turn to the following page for more on remote start
features).
Using Valet / Service Mode