Using the security and keyless entry features – Code Alarm CA-630 User Manual

Page 5

Advertising
background image

5

Using the Security and Keyless Entry features

(cont.)

Activating Trunk Release Feature

(vehicle must have power trunk/hatch)

Press and hold the UNLOCK button for 2 seconds to open the vehicle
trunk or hatch.

Using the Progressive Car Finder Feature

Press the FIND/PANIC button on the remote control to locate your
vehicle. The horn will emit five short chirps at low volume, increasing
in volume each of three times the button is pressed.

Personal Protection Alarm (Panic)

Press and hold the FIND/PANIC button to activate the vehicle horn
and parking lights for 30 seconds. (If the vehicle horn is connected,
the horn will “pulse” for 30 seconds.) Press any remote control button
to turn off the “Personal Protection Alarm”.

How your IT-s

TM

Interior Theft Sensor Protects Your Vehicle

Your sensor is designed to respond to impact to critical vehicle
surfaces. It is a dual stage sensor. A light, non-damaging impact will
cause the vehicle horns to emit a short “chirp”. A harder, damaging
impact will cause the vehicle horn to emit a continuous honking
sequence.

Disabling the IT-s

TM

Interior Theft Sensor

It may be necessary at times to disable the IT-s

TM

Interior Theft Sensor,

especially when parking in areas (like parking garages) where
extreme vibration may cause false alarms. Press the LOCK button and
then press the FIND/PANIC button within two seconds of pressing
LOCK to disable the interior theft sensor. The horn will chirp two times
to indicate that the sensor is disabled. The sensor will become
enabled again the next time the system is armed normally.

Attempted Intrusion Identification

In the event that the security system was triggered in your absence
the blue dash mounted LED will be rapidly flashing and upon
disarming/unlocking the vehicle the siren/horn will chirp 4 times. To
determin which zone triggered the system enter the vehicle and press
and release the valet button one time, the siren/horn will chirp as
listed below to indicate the triggered zone. NOTE: DO NOT turn on
the vehicles ignition, doing so resets the intrusion ID.

SHOCK

1 Chirp

DOOR

2 Chirps

HOOD

3 Chirps

IGNITION

5 Chirps

Advertising