Industrial Injection FORD 6.7L Compound Turbo User Manual
Page 42
Advertising
Pg. 43
Tighten up the two 13mm bolts on the bottom of the turbo first, then proceed to tighten up your V-Band
clamps and the 7/16” nuts on the large clamps of the Compressor and turbine housings, as well as the
T6 flange bolts.
Install the provided intake filter elbow on the front of the Turbo. You will need to use a red hot knife to
cut a rectangular hole in the rubber elbow for the MASS airflow sensor. This rubber is very hard, you can
use a drill bit to pre drill holes for the two screw holding the sensor in.
Advertising