M2TECH Young - Manual (Page 5)

YOUNG
384
k H z /32bit digital-TO-ANALOG CONVERTER
REVISION 1.o – NOVEMBER 2010
Copyright © 2010, M2Tech Snc di Manunta & Marino
5
M2Tech
www.m2tech.biz
1. Unpacking and placing the unit
Place the carton box on a table and open it by removing or cutting the adhesive tape.
Extract the foam upper cover. You should find the following items:
• one Young DAC;
• one wall adapter;
• one A-B USB cable;
• a sheet with indications about how to obtain this manual and the drivers.
Should one or more items be missing, please contact your dealer or local distributor.
Extract the Young from the foam container and place it on a stable base, far from heat
sources. Avoid the direct sunlight on the unit. Allow for enough room around the unit for
venting. The Young is a high efficiency design so little heat is produced during normal
operation; anyway, it’s better allow for adequate venting. Avoid smoke, humidity, moisture
and water from reaching the unit.
Do not place the unit on thick carpets or inside a box or piece of furniture, or in close
contact with curtains.