M2tech, Connecting and powering the unit – M2TECH Young User Manual
Page 8
YOUNG
384
k
H
z
/32bit digital-TO-ANALOG CONVERTER
REVISION 1.o – NOVEMBER 2010
Copyright © 2010, M2Tech Snc di Manunta & Marino
8
M2Tech
www.m2tech.biz
4. Connecting and powering the unit
Please refer to section 3, “Back Panel Description”.
Connect the “B” plug of a 2.0 USB A-B cable to the USB connector (Figure 2, 10) of the
Young.
Connect the “A” plug of the cable to a 2.0 USB port of your computer.
Connect two interconnects to the analog outputs of the Young (Figure 2, 4/5) and to the
input of your amplifier/preamplifier.
Connect digital cables from your digital sources (CD player, DAT tape recorder,
DAB/DVB/sat tuner) to the Young’s digital inputs (Figure 2, 6-9).
Connect the power supply or any other 15-18V/500mA power supply to the supply
connector (Figure 2, 11) of the Young. The Young will activate.
If a driver hasn’t been installed on your computer, an automatic driver installation wizard
may appear.
Note: If you want to avoid the automatic driver installation, please connect the
Young to the computer after manually installing the driver (see section 5).