M2TECH Marley - Manual (Page 28)

marley
DUAL-DRIVE CLASS-A HEADPHONE AMPLIFIER / PREAMP
REVISION 1.0 – NOVEMBER 2013
Copyright © 2013, M2Tech Srl
28
M2Tech
www.m2tech.biz
6.10. Switch-Off
The MARLEY may be turned off by a long push on the button on the left of the front
panel (Figure 1, 1). After a few seconds, the advice shown in Figure 15 appears.
POWERING-DOWN
RELEASE BUTTON
Figure 15
Once the button is released, the unit switches off and may be turned on again by a
new short push on the button.
NOTE: In the “Off” status, the MARLEY
MARLEY MARLEY MARLEY actually draws a very low current, such as
it may be considered negligible.
6.11. Notes About Menu Use
When the firmware release screen is displayed and the encoder knob is pushed
further, menu navigation restarts from the first item not related to volume control that
is from source selection. If the volume setting mode is desired, it’s then necessary to
exit the menu by either pushing the button on the left of the front panel (Figure 1, 1)
or avoid operating the unit for a while, to allow the MARLEY to automatically revert to
“idle” status.