M2TECH Van der Graaf - Manual (Page 12)

VAN DER GRAAF
VERY LOW NOISE POWER SUPPLY
REVISION P R A – JUNE 2014
Copyright © 2014, M2Tech Srl
12
M2Tech
www.m2tech.biz
order with regards to activation, by pushing this button. In the process, LED 3 blinks.
At the end of disable process, LED 3 turns off.
2) Single output enable buttons. When the VAN DER GRAAF is active (both LED 4
and 3 on), it is possible to toggle each output by pushing the related button.
3) General enable LED. It’s on when the VAN DER GRAAF is active. It blinks when
enabling and disabling outputs.
4) Power on LED. It’s on when the VAN DER GRAAF is powered.
5) Single output enable LED’s. Each LED is on when the related VAN DER GRAAF
output is enabled.