M2tech, Overload and protection – M2TECH Van der Graaf User Manual
Page 21
VAN DER GRAAF
VERY LOW NOISE POWER SUPPLY
REVISION P
R
A – JUNE 2014
Copyright © 2014, M2Tech Srl
21
M2Tech
www.m2tech.biz
7. Overload and Protection
All Van Der Graaf outputs are protected against unwanted overloads by solid state,
automatically resettable fuses. Anyway, continuous short-circuits may damage the
unit and must always be avoided.
In case of overload or short-circuit at one output, the behaviour of the unit is such that
other outputs may be affected.
Whenever an overload condition is detected, it’s recommended that user turns the
VAN DER GRAAF off and detaches all powered units. Each unit must then be checked
with its stock wall adaptor to find out which unit is defective.
Then working units may be connected back to the VAN DER GRAAF.