Magnum Dynalab MD-109 - Manual (Page 4)

UNPACKING YOUR MD 109
Carefully inspect all sides of the shipping carton for damage. If there are marks or
holes in the carton, make note of the location in relation to the unit inside. Any
obvious dents or scuffmarks should alert you to the possibility of damage. Open
the top flaps and carefully lift the transport case out of the carton. Carefully
remove the MD 109 from the box and wrapping, inspect all sides. Pay special
attention to the corresponding areas on the unit where damage if any was found
on the shipping carton. If damage is evident, document the type and extent of the
damage, then repack the unit and call the dealer.
If your unit was delivered by a common carrier (Eg. UPS) and you have found it to
be damaged, contact the carrier immediately for instructions.
KINDLY DO NOT SEND THE UNIT BACK TO THE SHIPPER UNTIL YOU HAVE BEEN
ASKED TO DO SO. SHIPPNG THE UNIT BACK PREMATURELY MAY VOID ANY
CLAIM FOR DAMAGE THAT YOU MAY HAVE.
DO NOT DISCARD THE PACKING MATERIALS AND CARTONS. Should you need to
return the unit for any reason, it must arrive safely and suitably packaged in order
for our receiver to accept it from the carrier. Also, if the unit has incurred
damage as a result of improper packaging, it is not likely that a claim for the
damage against the carrier will be successful.
Likewise, when applicable we will ship your unit back to you only in factory-
approved packaging. However, if the unit were to arrive at our factory in anything
other than factory approved packaging, we reserve the right to re-pack the unit in
factory-approved packaging and charge the cost of the packaging to the shipper.
This is the only way we can assure you of a safe return (damage by carrier
excepted).
- 4 -