Citizen Systems iDP3240 - Manual (Page 38)

— 18 —
1
Turn off the power of the printer.
2
Open the printer cover.
3
Cut the paper near the paper
insertion slot.
4
Move the head springs on both sides
in the direction of arrows to unhook
them from the chassis hooks, and lift
them up.
5
Hold and lift the platen levers, and
the platen roller unit can be
removed.
6
Remove any paper remaining in the
paper path.
7
Holding the platen roller unit in the
correct orientation, install it into the
printer with its bushes fitted in the
bush guides on the chassis.
8
While pushing on the platen roller
unit lightly, lower the head springs
to hook them to the chassis hooks.
4.6 Removing Paper Jams
CAUTION:
• Do not attempt to do anything inside the printer immediately after printing because
the head and motor are very hot.
• Do not force the head springs to move beyond their moving range.
• When removing remaining paper, do not touch the heated surface of the head with
bare hand or with metal.
• After inserting the platen roller, be sure to confirm that it has been set correctly.
• When removing the platen roller unit, the power must be turned off.
Chassis hook
Head spring
Push guide
Platen roller unit
Push guide