Citizen Systems PPU-231II - Manual (Page 55)

— 53 —
GS ! n
[Function] Specifying the character size
[Code] <1D>H<21>H<n>
[Range] 0 n 255, where:
1 vertical magnification 8,
1 horizontal magnification 8
[Outline] Specifies the character size (Vertical and horizontal
magnification).
Bit Function
Value
Hex. Number Decimal Number
0
1 Vertical magnification Refer to Table 2, “Vertical
2 specification Magnification”.
3
4
5 Horizontal magnification Refer to Table 1, “Horizontal
6 specification Magnification”.
7
[Caution] • This command works for all ANK characters except for HRI
characters.
• This command is ignored if either the vertical magnification
or horizontal magnification is out of the defined range.
• In STANDARD MODE, the vertical direction is defined as the
paper feed direction, and the horizontal direction is defined as
the direction perpendicular to the paper feed. These definitions
are, therefore, interchanged when 90°-right-turned characters
are specified.
• In PAGE MODE, the vertical direction means the top-bottom
direction of each character. The horizontal direction means the
side-to-side direction of each character.
Table 2 Vertical Magnification
Hex. Decimal Magnification
00 0 1
×
(Standard)
01 1 2
×
(Double height)
02 2 3
Ч
03 3 4
Ч
04 4 5
Ч
05 5 6
Ч
06 6 7
Ч
07 7 8
Ч
Table 1 Horizontal Magnification
Hex. Decimal Magnification
00 0 1
×
(Standard)
10 16 2
×
(Double width)
20 32 3
Ч
30 48 4
Ч
40 64 5
Ч
50 80 6
Ч
60 96 7
Ч
70 112 8
Ч