PDR Mounts pmsw50u - Manual (Page 2)

the strength of the wood beam is not sufficient, add reinforcement.
Always confirm the center of the beam is used for the installation.
Avoid installing in locations where the temperature and humidity are excessively high, and where contact with any
not install in locations where there are excessive amounts of dust,
Do not block the ventilation holes. Leave sufficient clearance in regard to the surroundings to avoid blocking the ventilation. .
The internal temperature could elevate and possibly result in fire. Install the projector (4") or more away from surroundings. .
Do not install in locations where there is excessive vibration or impact. Injury and damage could result from the projector mount
light. Strong light could result in eye fatigue during usage.
Use the specified bolts and screws in the specified places and tighten firmly. Failure to do this could cause injury if the projector
could result with injury due to the projector mount falling. .
C a u t i o n : I n s t a l l a t i o n o f u n i t i s t o b e c a r r i e d o u t b y q u a l i f i e d t e c h n i c i a n s o n l y . I n s t a l l i n a n a p p r o p r i a t e
l o c a t i o n b y c h e c k i n g t h e w a l l s t r u c t u r e a n d d u r a b i l i t y f o r s a f e t y a n d a c c i d e n t p r e v e n t i o n .
INSTALLATION LOCATION
INSTALLATION ON A WOODEN CEILING STRUCTURE
Always install so that the load is supported by a wood beam. If
Do not install on decorative ceilings or plaster board.
water is possible. These can result in fire or electric shock.
Do not install close to an air conditioner intake or outlet. Do
oily smoke or tobacco smoke. Fire could result.
.
falling.
Do not install where there is direct sunlight or other strong
mount falls.
Do not alter any of the parts. Do not use broken parts. This
Note:
CAUTION
WARNING
WARNING
REV 072808
The ceiling where the mount is to be installed must be capable of long-term support of
the total load of the projector and mount. Measures should be taken to ensure sufficient
strength to withstand the force of earthquakes, vibrations and other external forces.
Incorrect installation can cause the projector mount to fall and cause injury.
Total load of the mount (projector + Mount)
Maximum weight - 55 Lbs (25Kg.)
2