PDR Mounts pmsw50u - Manual (Page 6)

1: Start by screwing the leveling barrels ( A ) into the Adjustable arms (K and L). A screwdriver slot is provided in the barrel (A). The barrels only
need to be threaded approx. 1/8“ through the bottom of the arm (K and L). If the mounting plane of the projector is not flat, the barrels can be
adjusted to make up the difference in height.
SEE FIG 1
2: Using the adapter plate ( M ) attach the adjustable arms ( K,L ) with the hardware supplied (B,C,F). No need to tighten at this time. SEE FIG 1
3: Place the Universal adapter plate onto the projector. Using the proper hardware supplied ( screws G,H,I,or J) (washers D or E )
lightly fasten to the projector.
SEE FIG 4
4: Position the universal adapter plate approx over the center of the projector. Tighten the screws to the projector and then tighten the plastic knobs
(If needed you can also adjust the adapter plate assembly to access the filters and light source, or for lateral shift to suit)
Be careful to not over-tighten the projector screws.
Damage to the projector may occur if the screws to the projector are over tightened.
3. ATTACH THE ADAPTER PLATE TO THE PROJECTOR.
Fig 4
Projector assembly
Adapter Plate Assembly
4. MOUNT THE PROJECTOR ASSEMBLY TO THE PROJECTOR MOUNT
Fig 4
1: Place the projector assembly into the bayonet slots on the mount (small end into large end) and slide backward until
the safety lever engages SEE FIG 5.
2: Adjust the locking thumb screws to secure the mount to the projector.
3: To remove, loosen the thumb screws and lift the safety lever to slide the unit out.
4: Using a #2 phillips screw driver, insert into the pitch or yaw hole and engage the gear, Turn the screw driver and adjust to suit.
After adjustments are made tighten the side screws.
Locking thumb screw
Yaw adjustment hole
Safety lever
Projector assembly
Bayonet Sub Assembly
6
Pitch adjustment
Side screws
Side screws