PDR Mounts pmsw50u - Manual (Page 5)

1. FASTEN THE PROJECTOR MOUNT TO 1 ½”NPT PIPE
1: The bracket must be secured to a ceiling structure capable of at least
2: Screw the bayonet sub assembly onto the 1 ½” NPT pipe (not supplied).
3: Secure with the locking set screw making sure the sub assembly
safety lever is facing the front of the projector.
4: Fine adjustment can be made for rotation by loosening the two screws on the 1 ½’collar and rotating to the desired
position and tighten the two screws.
SEE FIG 2
(4) times the weight of the projector + mount.
Fig 2
Fig 3
2. FLUSH MOUNTING THE PROJECTOR MOUNT
safety lever
Rotation screws
locking set screw
1 ½”npt Pipe Not Supplied
Bayonet Sub Assembly
1 ½”npt collar
Projector Front
1: The bracket must be secured to a ceiling structure capable of at least (4) times the weight of the projector + mount.
2: For flush mounting of the pmsw50u remove the 1 ½” collar and the side screws.
3: Position the pmsw50u mounting plate against the ceiling structure with the chamfer facing the rear of the viewing screen (a solid wood
construction is required behind any ceiling structure).
SEE FIG 3
4: Using the two lag bolts and washer supplied fasten to the ceiling.
5: Re-attach the bottom part of the mount and micro adjustment gear using the side screws removed earlier.
SEE FIG 3
Chamfer facing away
from the viewing screen
Wood beam
Front of mount
Side screws
5
O
P
Micro adjust gear